Driving
5.3 Driving the truck crane and switching it off
Operating Manual GMK6300L 3 112 xxx en 5 - 41
xx.xx.xxxx
While driving • Observe all warning messages.
On the instrument panel
– If one of the lamps (1) which has already been checked lights up again,
refer to the information in the previous section.
– When one of the lamps (1) lights up, stop the truck crane immediately and
check the message;
à p. 5 - 54.
–When the
ECOS display shows a warning message (1);
à Warning submenu, p. 5 - 48.
• Also note the control elements for fuel level
and carbamide level where applicable,
engine speed, coolant temperature, trans-
mission and hydraulic oil temperature;
à p. 4 - 20.
S
Risk of damage if warning messages are disregarded!
After a warning message appears (on the
ECOS display or combination
instrument
display), always promptly observe all information in the section
titled
Warning submenu, and take the appropriate corrective measures. This
prevents these malfunctions causing defects in the truck crane.
1)
Additional equipment
To Next Page
Loading...
Need help?
General
