Crane operation
11.2 Operation of the rated capacity limiter
Operating Manual GMK6300L 3 112 xxx en 11 - 21
xx.xx.xxxx
After the test program:
– the lamps (1) and (2) light up,
– all power units are disabled.
The current display depends on whether the RCL either:
– was switched off for up to 48 hours, or
– was switched off for more than 48 hours.
After a standstill of up to 48 hours
The
Monitoring submenu opens.
The last set rigging mode will be displayed,
and symbols (1) and (2) will be green and
flash.
You can accept the displayed values if they
correspond to the current rigging mode:
• Press button (3) once – symbols (1) and (2)
will stop flashing.
Lamps (1) and (2) will go out. The RCL code has been applied.
If no error message is displayed, the RCL is set for crane operation and
crane movements are enabled;
à Checks before operating the crane, p. 11 - 31.
Any pending errors are indicated on the display (1);
à Display in the event of
errors
, p. 11 - 39.
You must re-enter the current rigging mode if the displayed values do not
correspond to the current rigging mode of the truck crane;
à Enter rigging
mode
, p. 11 - 23.
s
To Next Page
Loading...
Need help?
General
