Rigging work
12.9 Other rigging work
12 - 118 3 112 xxx en Operating Manual GMK6300L
xx.xx.xxxx
• Switch off the ignition in the crane cab.
Installing
• Clean the camera lens if necessary.
• Insert the camera (2) into the clamp (1) and
secure it with the retaining pin.
• Insert the plug (4) into the socket (3).
• Lay the cable (5) in such a way that it will not
be damaged.
G
Risk of accidents if the wrong camera is installed!
If you install the wrong camera in your truck crane, you will not see an
image.
If your camera is installed in a neighbouring truck crane, you will see the
wrong image.
G
Risk of accidents due to a falling camera!
Always use a retaining pin to hold the camera in the clamp.
This prevents the camera falling down and injuring someone.
To Next Page
Loading...
Need help?
General
