3-26
Setting Cleaning during Printing
It is set whether head cleaning is performed automatically during printing.
In cleaning during printing, a cleaning interval is set according to the length of a printed medium.
Printing is interrupted each time a medium is printed for the set length, and head cleaning is performed
automatically during the interval.
1
Press the key in LOCAL to select the
printing mode.
2
Press the key.
3
Press the key.
4
Press to select one of the types (1 to 4) and press the key.
5
Press to select [Print. CLEANING].
6
Press the key.
7
Press to select ON.
• When selecting OFF, proceed to Step 10.
8
Press the key.
9
Press to set a cleaning interval and
a cleaning type.
Item selection: Select one with .
Setting of an interval and type:
Set an interval and type with .
10
Press the key.
• Press the key several times to end the setting.
Set Item Set Value Overview
INTERVAL 10 to 1,000 mm
Interval between each cleaning operation (print length)
TYPE
NORMAL / SOFT /HARD A cleaning type is selected.
• This function does not operate when ink near-end occurs. See P.1-14 "Changing an Ink Cartridge" to
solve the ink near-end.
• Depending on the state of the heads, etc., the image quality deterioration may not be improved even
with this function performed. In this case, contact our service office or the distributor in your region.
<LOCAL. 1> [ #01 ]
WIDTH:****mm
FUNCT I ON
SETUP <ENT>
SETUP
SELECT : TYPE . 1
[1]
Pr i nt . CLEANING<ent>
[1]Pr int . CLEANING
SETUP :
OFF
[1]Pr int . CLEANING
SETUP :
ON
I NTERVAL : TYPE
1 000mm :NORMA L
INTERVAL :TYPE
1 000mm :NORMA L
INTERVAL:
10 to 10,000 mm
TYPE： NORMAL
SOFT
HARD
To Next Page
Loading...
Need help?
General