MIMAKI JV5 Series Operating Manual

6-9
Maintaining the Capping Station
6 6
Maintenance
Before Washing the Ink Discharge Passage
Before the ink discharge passage (PUMP tube) is washed, it needs to be filled with cleaning solution for
maintenance.
Filling the Pump Tube with Cleaning Solution for Maintenance
1
Press the key in LOCAL to select the
printing mode.
2
Select [HD. MAINTENANCE] of the maintenance menu.
(1)Press the key.
(2)Press to select [MAINTENANCE] and press the key.
(3)Press to select [HD. MAINTENANCE].
(4)Press the key.
3
Press to select [Maint WashLiquid].
4
Press the key.
5
Press the key.
• When a normal cartridge has been set,
proceed to Step 6.
6
Set a cartridge.
7
Press the key.
• The cartridge starts to be filled with cleaning solution.
• When the following messages are displayed, check the waste ink tank and perform the operations
described on P.6-37 "If a Waste Ink Tank Confirmation Message Appears" as necessary.
Con f i rm a was t e tan k
Con t i nue< >Exchange
Con f i rm a was t e tan k
Exchange :
e nt
<LOCAL. 1> [ #01 ]
WIDTH:****mm
HD . MA I NTENANCE
MaintWashLiquid<ent>
MaintWashLiquid
FI LL ING UP <en t >
MaintWashLiquid
CARTRIDGE : none
When "END" is displayed:
There is no cleaning solution in the
cartridge. Set a new cleaning solution
cartridge.
When "Abnormal" is displayed:
The set cartridge does not contain
cleaning solution.
MaintWashLiquid
FILLING UP START:
e nt

MIMAKI JV5 Series Specifications

General

Brand	MIMAKI
Model	JV5 Series
Category	Printer
Language	English