MIMAKI JV5 Series Operating Manual

2-10
Installing Tools
This machine allows you to use the following tools:
Cutter : This tool is selected when an image printed on a medium is cut or when
letters are cut with a cutting medium.
Pen (water-based ballpoint pen) : This tool is used to perform “test printing” for checking how images or
letters are cut actually.
When a Cutter Is Used
Mounting a Cutter Blade
1
Remove the cutter holder.
2
Loosen the locknut and remove the adjustment knob
from the holder.
3
Insert a cutter blade in the hole of the adjustment
knob.
• Pick up the cutter blade with tweezers.
4
Tighten the locknut.
• Do not touch the cutter with your fingers.
The sharp blade edge of the cutter may cause you to get injured.
• Do not shake the tool after having set the cutter.
Otherwise, the blade edge may pop out, causing you to get injured.
• Store the cutter blade in a place that is out of the reach of children.
In addition, dispose of used cutter blades according to regional laws and regulations.
Locknut
Adjustment knob

MIMAKI JV5 Series Specifications

General

Brand	MIMAKI
Model	JV5 Series
Category	Printer
Language	English