2-42
Data Cutting
Starting a Cutting Operation
Also when printing data with a pen, follow the procedure below.
1
When the machine is in a REMOTE state, the PC transmits data to be cut.
• The pressure is switched automatically in concert with the pinch
roller pressure set in P. 4-3 "Setting for the Pinch Rollers".
• When the machine has received the data, the data starts the cutting
automatically.
• When the cutting has been completed, the display appears as the
one shown right.
Stopping cutting in a while
If you stop cutting or pen plotting in a while, perform the following operation.
1
Press the key while the machine is operating.
• The operation of the machine stops in a while and it enters a local state.
• The time it takes for the operation of the machine to stop is different, depending on the data being
processed.
When a circle is processed: After the circle has been processed, the operation stops.
Other line segments : After they have been processed by the unit of vector, the operation
stops.
Restarting a Cutting Operation
1
Press the key to restart a cutting operation.
• The machine enters a REMOTE state, and a cutting operation is restarted.
Functions That Can Be Set after a Cutting Operation Has Been Stopped
z Changing the tool condition
"About Tool Conditions during Cutting" of P.2-3
z Stopping a cutting operation of the received data
"Stopping a Cutting Operation (Data Clear)" of P.2-43
*REMOTE.C * [ #01 ]
CUT 1 ( 3 0 / 6 0 / 0 . 3 0 )
To Next Page
Loading...
Need help?
General