4-44
Setting the step size
For some application software (especially old ones), data output may possible only by different unit from the limit
of resolution. In such a case, change this setting value and make the cutting performed in correct size.
1
Press the key in LOCAL to select the
cutting mode.
2
Press the key.
3
Press to select [MAINTENANCE].
4
Press the key.
5
Press to select [STEP SIZE].
6
Press the key.
7
Press to select the setting value.
• Setting value : 0.01 or 0.025
8
Press the key.
9
Press the key several times to return to LOCAL.
<LOCAL .
C
> [ #01 ]
CUT 1 ( 3 0 / 6 0 / 0 . 3 0 )
FUNCT I ON
C
SETUP <ENT>
FUNCT I ON
C
MA I N T ENANCE < EN T >
MA I N T ENANCE
MARK S ENSOR < e n t >
MA I N T ENANCE
STEP S I ZE <en t >
STEP S I ZE
SIZE =
0
.025
STEP S I ZE
SIZE =
0
.01
To Next Page
Loading...
Need help?
General