MIMAKI JV5 Series Operating Manual

4-45
4
Extended Functions – Cutting –
Other Convenient Functions
Medium feeding
Before you start cutting or printing with a pen, feed a certain length of
the medium to allow a margin.
By feeding the sheet beforehand, you can check for a skew of the
medium or prevent a skew while cutting the long data (or printing the
long data with a pen).
1
Press the key in LOCAL to select the
cutting mode.
2
Press the key.
3
Press to input the feed amount.
• Set value: 0.1 m to 51.0 m (by the unit of 0.1 m)
4
Press the key.
• The medium will be fed by the input length.
• If you start high-speed cutting without feeding a certain
length of the roll medium beforehand, the medium may
not be fed properly, causing an error in the machine.
• The key does not work until the medium is
detected.
• Press the key to stop the medium feeding.
• If the length of the medium is shorter than the set value, sheet feeding stops, displaying the fed medium
length. In this case, press any key to clear the display.
<LOCAL . C > [ #01 ]
CUT 1 ( 3 0 / 6 0 / 0 . 3 0 )
MED I A F E E D
:0.1m
MED I A F E E D
:1.5m
** MEDIA FEED **
:*.**m

MIMAKI JV5 Series Specifications

General

Brand	MIMAKI
Model	JV5 Series
Category	Printer
Language	English