3-6
Setting for the pinch rollers
This section describes the setting procedure for CJV30-160.
For CJV30-130/100/60, the number of pinch rollers set in Step 10 varies.
1
Press the key in LOCAL to select the
printing mode.
2
Press the key.
3
Press the key.
4
Press to select one of the types (1 to 4) and press the key.
5
Press the key.
6
Press to set the pressure for the pinch
rollers at both ends of the medium.
• Set value: HIGH/MID./LOW
7
Press to move the cursor to the
middle pinch roller setting.
End pinch roller
(left end)
End pinch roller
(right end)
Middle pinch rollers
• The figure above shows CJV30-160.
Pinch
Roller
Pinch
Roller No.
<LOCAL. 1> [ #01 ]
WIDTH:****mm
FUNCT I ON
SETUP <ENT>
SETUP
SELECT : TYPE . 1
ENDS : H IGH [H_____H]
INNER:OFF No.7-1
ENDS : M ID. [H_____H]
INNER:OFF No.7-1
ENDS :MID. [H_____H]
INNER:
OFF No . 7 - 1
To Next Page
Loading...
Need help?
General