6-36
Printing the Remaining Amount of a Medium
The present remaining amount of a medium can be printed.
1
In LOCAL, Press .
• LOCAL changes to the origin setting mode.
2
Press to set the origin to a desired position.
• Move the carriage and medium with and set the
origin.
• When you do not change the origin, do not press
and proceed to Step 3.
• When you press the key here, the origin is changed, and
the screen returns to LOCAL.
3
Press the key.
• When you press ,
the screen returns to Step 2.
• When you press the key, the screen returns to LOCAL.
4
Press the key.
• The remaining amount of a medium starts to be printed.
• When the printing has been completed, the screen returns to LOCAL.
• Set "Remaining amount of a medium to display" to "ON".
• When you replace the medium you use now with another, it is recommended that you print the
remaining amount of the medium on it. With the remaining amount of a medium having been printed
beforehand, when you use the replaced medium again, you can enter an accurate value in the screen
for entering the remaining amount of a medium ( P.2-29) that appears after media detection.
• When the remaining amount of a medium has been printed with the origin changed, the origin set here
is effective even when subsequent data are printed.
OR I G I N SE TUP
0.0 ----
OR I G I N SE TUP
0.0 ----
Origin
position
(length)
Origin
position
(width)
MED I A RES I DUA L PR I N T
<ENT>
To Next Page
Loading...
Need help?
General