NAiS FP1 User Manual

2. Differences Between the FP Programmer and FP Programmer II
The FP Programmer II is designed to support all the functions of the FP1 programmable controllers described in this
manual. Differences in functions between the FP Programmer and the FP Programmer II are explained in the table.
■ FP Programmer (AFP1112 and AFP1112A) and FP Programmer II(AFP1114)
Note:
• * The availability of instructions and functions depends on the type of the programmable controller and
the CPU version. For details about functions available for FP1 CPU version 2.7, refer to page 245, “8-
7. FP1 CPU Version 2.7”.
Item
Programmable
controllers supported
Communication
parameters
36 comparison
instructions (ST = etc.)*
NSTL instruction*
F12 (ICRD)/P12
(PICRD), F13
(ICWT)/P13 (PICWT),
F14 (PGRD)/P14
(PPGRD) instructions*
F64 (BCMP)/P64
(PBCMP), F98 (CMPR)/
P98 (PCMPR), F99
(CMPW)/P99 (PCMPW),
F157 (CADD)/P157
(PCADD), F158 (CSUB)/
P158 (PCSUB)
instructions*
FP Programmer
(AFP1112)
FP1, FP3, FP5
Fixed as:
Baud rate:
Character
bits:
Parity:
Stop bit:
Not available
Not available
Not available
Not available.
These instructions
cannot be programmed .
However, you can
monitor the instructions
with it.
FP Programmer
(AFP1112A)
FP1, FP3, FP5
The parameters are
automatically adjusted
when connected to the
programmable
controller.
Baud rate:
Character
bits:
Parity:
Stop bit:
Not available
Available
Not available
Available
FP Programmer II
(AFP1114)
FP-M, FP-C, FP1, FP3,
FP5, FP10S, FP10
The parameters are
automatically adjusted
when connected to the
programmable
controller.
Baud rate:
Character
bits:
Parity:
Stop bit:
Available
Available
Available
Available
19,200 bps
8 bits
ODD
1 bit 19,200 bps
or 9,600 bps
8 bits or
7 bits
ODD
1 bit
19,200 bps
or 9,600 bps
8 bits or
7 bits
ODD
1 bit
243
8-6. Versions of Programming Tools

NAiS FP1 Specifications

General

Brand	NAiS
Model	FP1
Category	Controller
Language	English