10 - 13
10 IO-Link Master Unit
GX-series EtherCAT Slave Unit User’s Manual
10-4 Specifications
10
10-4-2 Part Names and Functions
Precautions for Correct Use
The characters at the top of the node address setting switches depend on the unit version of the
IO-Link Master Unit as follows:
10-4-2 Part Names and Functions
No. Name Function
(1)
EtherCAT communications
connector, IN
EtherCAT cable connection: IN side
M12 connector (D-coding, female)
(2)
EtherCAT communications
connector, OUT
EtherCAT cable connection: OUT side
M12 connector (D-coding, female)
(3) Power supply connector
Connects to Unit power supply and I/O power supply cable.
M12 connector (A-coding, male)
(4) I/O connectors
Connect to IO-Link sensor cables (IO-Link connector type: Class
A)
M12 connectors (A-coding, female)
(5) Node address setting switches Used to set the EtherCAT node address.
(6) Status indicators
Indicate the current status of the EtherCAT Slave Unit.
(RUN, ERR, L/A IN, L/A OUT, UNIT PWR, and I/O PWR)
(7) I/O indicators
Indicate the I/O status.
(C/E and C/Q)
(8) Mounting holes Used to mount the Unit with M5 screws.
Unit version Characters
Unit version 1.0 NODE ADDRESS
Unit version 1.1 or later ID
(4)
(1)
(4)
(2)
(8)
(6)(3)
(7)
(8)
(5)
To Next Page
Loading...
Need help?
General
