6-110
Digital Operator Functions
îš‹ Setting Digital Operator Functions
îš„Related Parameters
îš„Monitor Selection (o1-01)
Using parameter o1-01 the third monitor item that is directly displayed in Drive Mode can be selected. This
parameter is only effective when the LED Digital Operator is used.
îš„Monitor Display when the Power Supply is Turned ON (o1-02)
Using parameter o1-02 the monitor item (U1-) that is displayed on the Digital Operator when the power
supply is turned ON can be selected.
Parameter
Number
Name
Setting
Range
Factory
Setting
Change
during
Opera-
tion
Access
Level
o1-01
Monitor selection
*1
*1. This parameter is effective only when the LED Digital Operator is used.
6 to 53 6 Yes A
o1-02 Monitor selection after power up 1 to 4 1 Yes A
o1-03 Digital operator display scaling
0 to
39999
0NoA
o1-09
Frequency reference display unit selection
*2
*2. Parameter function is only valid if a Digital Operator with LCD clear text display is used (LCD or HOA Digital Operator).
0 to 11 0 No A
o2-01
LOCAL/REMOTE key enable/disable
*3
*3. This parameter is effective only when the LED or LCD Digital Operator is used.
0 or 1 1 No A
o2-02
STOP key during control circuit terminal operation
*3
0 or 1 1 No A
o2-03 User parameter initial value 0 to 2 0 No A
o2-05 Frequency reference setting method selection 0 or 1 0 No A
o2-06
Operation selection when digital operator is discon-
nected
0 or 1 0 No A
o2-07 Cumulative operation time setting
0 to
65535
0 hrs No A
o2-08 Cumulative operation time selection 0 or 1 0 No A
o2-09 Initialize Mode 1 to 5 2 No A
o2-10 Fan operation time setting
0 to
65535
0 hr. No A
o2-12 Fault trace initialize 0 or 1 0 No A
o2-14 kWh monitor initialize 0 or 1 0 No A
o2-15
HAND Key function selection
*4
*4. This parameter is effective only when the HOA operator JVOP-162 is used
0 or 1 0 No A
To Next Page
Loading...
Need help?
General