Cleaning
QL-300 User Guide 392
6 Select Execute, and press the OK button. The printing for cleaning starts.
You cannot reuse cleaning paper.
Dispose of the cleaning paper that you print.
After cleaning is finished, remove the cleaning paper, load new paper, and start printing.
Cleaning the Cutter Unit
Do not dismantle any parts other than those specified in this procedure. Malfunctions could
occur.
You should do daily maintenance to keep the machine in good condition as you use it. Check
the condition of the machine when you start and stop using it, and clean it if needed.
Cleaning the Cutter Blades
Glue on the labels gradually accumulates on the cutter’s blades while cutting roll paper. This
causes problems with cutting and feeding.
Glue is more likely to accumulate on the cutter’s blades when using continuous label paper
(because the part being cut has glue on it). Clean the cutter’s blades periodically to prevent
cutting and feeding problems from occurring.
There is no specified frequency for cleaning, it depends on the type of roll paper being used
(liner/glue materials). If cutting or feeding problems occur, clean the cutter’s blades.
• Always turn off the power to the printer and remove the power cord from the electric outlet
before you start work.
• Use the specified tools for cleaning work.
• Do not touch the blades of the cutter with your bare hands. There is a risk of injury.
• Do not use any solvents other than alcohol or isopropyl alcohol.
• After cleaning, wipe the machine dry.
To Next Page
Loading...
Need help?
General
