Specifications
QL-300 User Guide 479
Other W1: Liner width 29.4 to 130 mm (1.1575 to 5.12 inches)
W2: Label width 25.4 to 126 mm (1 to 4.9606 inches)
W3: Right liner width 2 to 25.4 mm (0.0787 to 1 inch)
W4: Left liner width 2 to 25.4 mm (0.0787 to 1 inch)
L1: Black mark interval 15.7 to 1330.8 mm (0.618 to 52.3937 inches)
* The black marks contain carbon.
L2: Label length 12.7 to 1320.8 mm (0.5 to 52 inches)
L3: Gap between labels 3 to 10 mm (0.12 to 0.3937 inches)
L4: Cut size when in cut
mode
101.6 mm (4 inches) or more
However, if the length of one label is less than 101.6 mm
(4 inches), then the shortest length is 101.6 mm (4 inches)
as multiple sheets are cut
L5: Upper edge cutting
margin
1.7 mm (0.067 inches)
L5': Position of leading
edge of paper
1.2 to 4.0 mm (0.0472 to 0.1575 inches)
Length of leading margin when paper is loaded
L6: Lower edge cutting
margin
1.3 to 8.3 mm (0.051 to 0.3268 inches)
BW: Black mark width More than 5 mm (0.197 inches) from edge of paper;
maximum is width of paper W1 from edge of paper
BL: Black mark length 3 mm (0.12 inches) or more Upper edge is the same as
position of leading edge of label
A: Top margin 2.12 mm (0.0835 inches) or more
B: Bottom margin 2.12 mm (0.0835 inches) or more
C: Left margin 2.12 mm (0.0835 inches) or more
D: Right margin 2.12 mm (0.0835 inches) or more
Item Specification
To Next Page
Loading...
Need help?
General
