Performing
3535
Layering Zones
(Layer)
You can layer multiple tones so that they are heard simultaneously
when you play the keyboard. This type of setup is called a “layer”.
The FANTOM lets you layer the desired zones and play them as
layers.
1. Press the [ZONE SELECT] button to make it go
dark, and then press the ZONE [INT/EXT] buttons
to make them light up red.
Switch between ZONE
1–8/9–16
For this example, press the ZONE INT/EXT buttons for ZONE 1,
2, and 3 to make them light red.
MEMO
To make a ZONE 9–16 light red, press the [ZONE 1-8/9-16] button to
switch the target range of zones.
2. Press the [ZONE SELECT] button to turn ZONE
SELECT on.
3. Of the zones that are lit, press the ZONE SELECT
button of one zone to specify it as the current
zone.
MEMO
If ZONE INT/EXT Control is set to “Advanced”, the current zone lights
up green.
For this example, we specify ZONE 1 as the current zone of
the three ZONE 1–3 that are lit red. You are free to specify
ZONE 2 or ZONE 3 if you like.
Zone 1
Zone 2
Zone 3
When you play the keyboard in this state, the zones that are
lit red (ZONE 1–3) sound together.
NOTE
Zones whose ZONE [INT/EXT] buttons are lit green when the [ZONE
SELECT] button is dark are controlling an external MIDI sound
module.
To switch to the internal sound engine, once again hold down the
[SHIFT] button and press the corresponding ZONE INT/EXT button
to make the button light red (INT setting).
Selecting a Tone
(Layer)
1. Press the [ZONE VIEW] button.
The ZONE VIEW screen appears.
Select the VIEW number as appropriate for the zones that
are layered.
2. Switch the current zone and select a tone for each
zone.
Current Zone
Layered zone
3. Save the scene as described in “Saving a Scene”
(p. 56).
To Next Page
Loading...
Need help?
General
Weight and Dimensions
