7—Project and Drive Operations
100 www.Roland.com Roland VS-2000 Owner’s Manual
In the project list, you can also see all of the projects on the currently selected drive. The
VS-2000 provides information about each project.
Selecting an Item in the Project List
To select a project or drive shown in the project list:
1. Press
or
or turn the Time/Value dial until the desired item is outlined.
When an item is outlined and has an arrow pointing to it from the right, it’s selected.
To Display the Projects on a Drive
1. Select the drive. When a drive is selected, the LIST button appears
in the screen’s lower-right-hand corner.
2. Press LIST—the VS-2000 displays a list of the projects on the drive.
About “Store Current?” Messages
During the course of most PROJECT menu operations, the VS-2000 asks you:
The VS-2000 displays this message when an operation needs to temporarily borrow the
part of the VS-2000’s memory that holds the currently loaded project—after the
operation is complete, the VS-2000 re-loads the project from your hard drive. If you’ve
made any changes to the project since you last stored it, press ENTER/YES in response
to this message to ensure that those changes aren’t lost.
If you encounter error messages when working with your CD-R/RW drive, check
Page 368 or the
VS-2000 Appendices
to learn what the messages mean.
We’ll discuss write-protection, project sample rates and recording modes later on in
this chapter.
To view the contents of an audio CD, see “The CD Player Feature” on Page 368.
If a project is write-protected (Page 104), this message doesn’t appear, since the project
is locked to prevent the making of any changes to it.
SizeWrite-protect status Sample rate
Name Recording mode Creation date and time
Type of project
Project name
Position in project list
Sample rate and
recording mode
VS2000OMUS.book 100 ページ ２００４年１０月２０日 水曜日 午後３時３分
To Next Page
Loading...
Need help?
General
