4—Setting Up and Basic Operations
Roland VS-2000 Owner’s Manual www.RolandUS.com 79
Recalling Scenes
The VS-2000 can memorize up to 96 mix setups as “scenes.” Scenes allow you to:
• store and recall multiple versions of a mix.
• store and recall different versions of a project with different V-Tracks (Page 97).
“U Wanna Play Me” contains a couple of scenes that show off the way scenes work.
1. Hold down SHIFT and press LOCATOR•SCENE so it lights red.
Scenes—like locators—are stored in banks of 16 scenes each, numbered from 1-16.
Since Scene Bank 1 is already selected, we only need to enter each desired scene’s
second digit for the scenes in “U Wanna Play.”
2. Press TRACK/STATUS 2. Scene 02—containing a shortened intro—loads the
settings it contains.
3. Play “U Wanna Play” to hear how it sounds with Scene 02.
4. Press STOP when you’re done and keep your eyes on the display.
5. Press SCENE again, and then TRACK/STATUS 3 to recall Scene 03—this time a
vocal starts the song. The display shows it uses different V-Tracks than Scene 02.
6. Press ZERO and then PLAY to listen to the way the song’s changed.
To learn about storing scenes, recalling them and more, see “Scenes” on Page 142.
The VS-2000’s Built-It Tuner
The VS-2000 has its own chromatic tuner that you can use to make sure your
instruments are precisely in tune before you start recording, and can even check the
tuning of recorded tracks. The tuner works with any instrument connected to one of the
VS-2000’s XLR or 1/4” input jacks, or with any recorded track.
Tuning an Instrument with the VS-2000 Tuner
1. Connect the instrument to the desired input
2. Press TUNER—the CHROMATIC TUNER display appears.
3. Cursor to the SOURCE parameter and select the input to which you’ve connected
the instrument.
4. Set PITCH to the desired tuning reference. Concert pitch—A=440—is the default
setting.
5. To hear the instrument you’re tuning, press F1 (THRU) so it’s turned on (darkened).
When THRU is on, the tuner passes the selected input’s signal through to the
corresponding input channel.
You can recall scenes only while a project isn’t playing, so press STOP before
attempting to recall a scene.
VS2000OMUS.book 79 ページ ２００４年１０月２０日 水曜日 午後３時３分
To Next Page
Loading...
Need help?
General
