23—MIDI and Synchronization
288 www.Roland.com Roland VS-2000 Owner’s Manual
Sending SysEx Bulk Dump Data
1. Using a MIDI cable, connect the VS-2000’s MIDI OUT/THRU jack to the device to
which you want to transmit the SysEx bulk dump.
2. Navigate to the MIDI PARAMETER screen ((Page 283).
3. Set MIDI OUT/THRU to Out.
4. Press F5 (BlkDmp)—the MIDI BULK DUMP screen appears.
When you bulk-dump data from the VS-2000, all data selected for transmission on
this screen is included in the dump. Therefore, you’ll need to select what you want
to transmit in the dump. The screen is divided into three parts: SCENE, EZR Usr
Tmplt (“EZ Routing User Templates”) and Usr FX (“User Effect Patches”). Each
section has a BULK Tx (“Bulk Transmit”) Sw on/off parameter, and a BULK Tx
TARGET (“Bulk Transmission Target”) parameter.
5. To include scene data in the dump, turn on the SCENE section’s BULK Tx Sw.
6. Set the SCENE section’s BULK Tx TARGET parameter to:
•
ALL
—to include all of the current project’s scenes in the dump.
•
(Scene XX)
—to select a single scene to dump.
7. If you want to include EZ Routing user template data in the dump, turn on the EZR
Usr Tmplt section’s BULK Tx Sw and select a single EZ Routing template or ALL
templates for its BULK Tx TARGET parameter.
8. To include one or all of your user effect patches, turn on the Usr FX section’s BULK
Tx Sw parameter and set its BULK Tx TARGET to ALL or a selected user effect
patch.
9. When you’ve configured the contents of the bulk dump, press F1 (BULKTx) for
“Bulk Transmit.”
The VS-2000 asks if you’re sure you want to transmit the bulk dump.
10. Press ENTER/YES to transmit the SysEx bulk dump, or EXIT/NO to cancel the
operation.
A progress bar appears on the screen as the dump occurs. When the dump is
complete, the VS-2000 displays “Done!”
VS2000OMUS.book 288 ページ ２００４年１０月２０日 水曜日 午後３時３分
To Next Page
Loading...
Need help?
General
