Roland VS-2000 Owner’s Manual www.RolandUS.com 139
10—Using the Digital Mixer
In this chapter, we’ll discuss how to perform basic operations on the mixer. For an
introduction to the VS-2000’s built-in digital mixer, see Chapter 3.
Channel Selection
As described on Page 52, all of the VS-2000’s 40 mixer channels are active and available
at all times. Each of these sets of channels has its own area on the VS-2000.
• 10 input channels • 18 track channels • 6 stereo FX return channels
When you want to adjust a channel’s parameters, you must first select the channel.
When you select the channel, its CH EDIT parameters are displayed—”CH EDIT” is
short for “Channel Edit.”
Selecting an Input Channel for Editing
To select any of the input channels and display its CH EDIT parameters (Page 147),
press its round button in the INPUT area.
Selecting a Track Channel for Editing
To select any of the track channels and display its CH EDIT parameters (Page 147):
1. Press the CH EDIT button so it lights.
2. Press the desired track channel’s TRACK/STATUS button.
In addition to the instructions provided below, you can also use a connected mouse to
select any channel from the Channel Pop-Up menu, described on Page 71.
CH EDIT
button
TRACK/STATUS
buttons
Track Channels
1-18
VS2000OMUS.book 139 ページ ２００４年１０月２０日 水曜日 午後３時３分
To Next Page
Loading...
Need help?
General
