24—Using the Rhythm Track
Roland VS-2000 Owner’s Manual www.RolandUS.com 323
6. If you wish to save the current state of your project, press ENTER/YES. Otherwise,
press EXIT/NO.
7. When the VS-2000 pops open its CD-RW drive and asks you to insert the Rhythm
Track user backup CD you wish to recover, insert the disk in the drive, close the
drive, and press ENTER/YES—the RHYTHM TRACK USER BACKUP screen
appears.
8. Use the cursor buttons to highlight the data you wish to recover, and press F1
(MARK) to checkmark it.
9. Set CD Speed as desired. We recommend trying the maximum CD speed; if you
have any problems, lower the speed and try again.
10. Press F5 (OK)—the VS-2000 asks you to confirm the you want to proceed.
11. Press ENTER/YES to complete the recovery, or EXIT/NO to cancel the operation.
When recovery is finished, the VS-2000 displays the RHYTHM TRACK screen.
Turning Off the Rhythm Track
1. Press RHYTHM TRACK.
2. Set TRACK 17/18 Assign to Audio.
3. Press F6 (EXIT).
Rhythm track data you recover replaces any user rhythm arranges or rhythm patterns
currently stored in the selected partition, so be careful not to replace data you wish to
preserve.
VS2000OMUS.book 323 ページ ２００４年１０月２０日 水曜日 午後３時３分
To Next Page
Loading...
Need help?
General
