24—Using the Rhythm Track
322 www.Roland.com Roland VS-2000 Owner’s Manual
Muting the Rhythm Track
There are three ways to mute the Rhythm Track:
1. Bring Fader 17/18 all the way down.
2. Mute Track Channel 17/18. See “Mute Mode” on Page 141 to learn about muting.
3. Exit Rhythm Track mode and press CH EDIT to turn it off if it’s currently lit. Press
TRACK/STATUS 17/18 to un-light it.
Rhythm Track Backup and Recovery
While a project rhythm arrange or rhythm pattern is stored within a project, it’s backed
up during a project backup (Page 110). A user rhythm arrange or rhythm pattern, on the
other hand, belongs to the hard disk partition on which it resides—it’s not backed up
with a project that’s using it. User rhythm arranges and patterns have their own Backup
and Recovery operations. You back up an entire partition’s rhythm arranges and
rhythm patterns at the same time in a single process.
Backing Up a User Rhythm Arrange or Rhythm Pattern
1. Hold down SHIFT and press F1—the PROJECT LIST appears.
2. Select the partition whose user Rhythm Track data you want to back up if it’s not
already selected, and press F6 (LIST).
3. Press RHYTHM TRACK.
4. If “BACKUP” is not visible above F4, press the PAGE button so it is.
5. Press F4 (BACKUP)—the RHYTHM TRACK USER BACKUP screen appears.
6. Insert the requested media and press ENTER/YES, or press EXIT/NO to abort the
procedure. If you’re using a CD-RW disc that already contains data, the VS-2000
asks if you want to erase the disk. For details on the messages that may appear, see
Page 368.
7. Press ENTER/YES to erase the CD-RW, or EXIT/NO to cancel the backup.
8. Select whether or not you’d like the VS-2000 to verify the accuracy of your backup
once it’s been written on the CD. While this causes the backup to take a bit longer,
we recommend turning Verify on to make absolutely sure your project data’s been
correctly backed up.
9. We recommend trying the MAX setting that uses your drive’s fastest supported
speed. If you experience any problems, try a lower speed.
10. Press F5 (OK) to complete the backup. When backup is finished, the VS-2000
displays the RHYTHM TRACK screen.
Recovering a User Rhythm Arrange or Rhythm Pattern
1. Hold down SHIFT and press F1—the PROJECT LIST appears.
2. Select the partition into which you want to recover your backed-up Rhythm Track
data if it’s not already selected, and press F6 (LIST).
3. Press RHYTHM TRACK.
4. If “Recovr” is not visible above F5, press the PAGE button so it is.
5. Press F4 (BACKUP)—the VS-2000 asks if you want to save the currently loaded
project.
Since the Rhythm Track plays through Track Channel 17/18, you can also solo the
Rhythm Track if you wish. See “Solo Mode” on Page 142 to learn about soloing.
VS2000OMUS.book 322 ページ ２００４年１０月２０日 水曜日 午後３時３分
To Next Page
Loading...
Need help?
General
