16—Using Effects
Roland VS-2000 Owner’s Manual www.RolandUS.com 223
Saving Effect Patches
From the Algorithm View screen of an internal or VS8F-2-based effect processor—or
any of its edit screens—you can press F5 (SAVE) to store the patch’s current parameter
values as your own user effect patch (see “Preset and User Effect Patches” on Page 220).
When you press F5 (SAVE), the EFFECT PATCH SAVE screen appears, and the list of
200 user patches is presented. You can replace any of the current user patches with your
new effect patch.
Saving an Effect Patch
1. Hold down SHIFT and press F3.
2. Press the processor’s F button to display its Algorithm View screen.
3. Press F3 (EDIT).
4. Edit the patch as desired.
5. Press F5 (SAVE) to view the EFFECT PATCH SAVE screen.
To save an effect patch on the EFFECT PATCH SAVE screen:
1. Turn the Time/Value dial to select one of the 200 user effect patch memory
locations. The patch currently residing the selected location will be replaced with
the new patch you’re saving.
2. If you’d like to cancel the patch-saving operation, press F6 (CANCEL).
3. Press F5 (OK) to store your current patch settings as a new user patch in the
selected user memory location.
4. Press F1 (NAME) and name the new patch—to learn about naming, see Page 74.
5. Press F5 (OK) when you’re done.
To learn about using VS8F-3 effects, consult the VS8F-3’s documentation as well as the
documentation accompanying your third-party plug-ins.
Until you begin saving your own patches, all of the user effect patches are merely
copies of the first 200 preset patches, so feel free to replace any of them—you won’t be
losing anything you don’t already have as a preset patch.
VS2000OMUS.book 223 ページ ２００４年１０月２０日 水曜日 午後３時３分
To Next Page
Loading...
Need help?
General
