11—Input and Track Channel Tools
150 www.Roland.com Roland VS-2000 Owner’s Manual
3. ChLink
When CHLink (“Channel Link”) is turned on, the current channel becomes
linked to the channel next to it. If the current channel is:
•
odd-numbered
—it’s linked to the even-numbered channel to its right.
•
even-numbered
—it’s linked to the odd-numbered channel to its left.
When channels are linked, you can change a CH EDIT parameter’s value in both
channels at once by changing it in either of the linked channels. This can be especially
helpful when two channels control the left and right sides of a stereo signal.
When you link input or track channels, each resulting pair of inputs or tracks acts as a
single stereo object during routing, with a single input and output connection point.
4. AUX and FX Send Controls
•
The AUX Send Controls 1 and 2
—allow you to send a copy of the channel’s signal to
Aux Bus 1 and/or 2. These two bussed are connected to the AUX 1 and 2 output
jacks, respectively.
•
The FX Send Controls 1-6
—allow you to send a copy of a channel’s signal to any the
six possible effect processors, FX 1-6.
Each of the FX and Aux send busses has its own set of three controls.
•
The SENDS Knob switch
—When this parameter is checkmarked, it designates the
send to be controlled by the CH PARAMETERS SENDS knob (Page 167). The
VS-2000 remembers the setting for each channel, so whenever you select a channel,
the SENDS knob takes over control of the desired FX or AUX send.
You can quickly link channels by pressing the even-numbered channel’s INPUT or
TRACK/STATUS button while holding down the button for its odd-numbered partner.
When two channels are linked, their PAN and FADER parameters change in
appearance and behave differently. See Page 155 and Page 152, respectively, for more.
When you link two channels, their FADER parameter is set to 0dB or to their most
recent linked level value. When you unlink channels, they’re reset to 0dB.
When channels are linked, you can individually adjust their FADER and PAN settings
on the PRM.V— “parameter view”—screen (Page 164). You can press ENTER/YES when
the FADER parameter’s selected to jump to its parameter view.
The F.LINK parameter (Page 154) links only the channels’ FADER parameters if you
want to retain individual control of their other parameters.
To learn more about the FX and Aux sends, see Chapter 15.
SENDS Knob switch
Send Level
Send Status
VS2000OMUS.book 150 ページ ２００４年１０月２０日 水曜日 午後３時３分
To Next Page
Loading...
Need help?
General
