Commissioning (software)
6.2 Performing the configuration for the D4x5-2 offline
SIMOTION D4x5-2
184 Commissioning and Hardware Installation Manual, 02/2012
6.2.6 Loading a project, including sources and additional data
Overview
It is possible to download additional data (e.g. sources) to the target device when saving a
project to the CompactFlash card or downloading to the D4x5-2.
This data is required for:
● Online object comparison (e.g. additional properties)
● Various detailed comparisons (e.g. ST source file comparison)
● Synchronization with online objects
In order to be able to load a project's sources and additional data to the PG, this must be
specified in the project under "Options" > "Settings" > "Download" > "Store additional data on
the target device". Alternatively, this setting can also be made when the data is loaded to the
target device/target system.
If the sources and additional data have been saved on the CompactFlash card, the option
described in the sections that follow becomes available.
Project comparison
You intend to carry out servicing work on a commissioned system and have brought a
project on your PC/PG. This project is not consistent with the project on the D4x5-2 in the
system. In order to analyze the differences, perform an object comparison via "Start object
comparison".
You have the following options in terms of re-establishing consistency:
● In the object comparison, you can establish consistency for sources and technology
objects on an object-granular basis.
● Consistency can be established for the entire Control Unit by loading from the
CompactFlash card via "Target system" > "Load" > "Load CPU / drive unit to PG...".
Additional references
Detailed information on "loading data to the target device" can be found in the
SIMOTION
SCOUT Basic Functions
Function Manual.
To Next Page
Loading...
Need help?
General
