Connecting
3.3 Opening the front cover
SIMOTION D4x5-2
Commissioning and Hardware Installation Manual, 02/2012
47
3.3 Opening the front cover
Introduction
The interfaces on the front side of the D4x5-2 and the CX32-2 have a cover. This is opened
by swinging the front cover down; the interface connections are then accessible and can be
wired.
A hinge connects the front cover to the front of the housing. Once opened, the cover can be
removed. The front cover is closed by swinging it up; it automatically locks by means of a
hook at the top of the device housing.
Note
The cover of the D4x5-2 and CX32-2 can only be removed when it has been swung open
through approx. 45°.
Procedure for D4x5-2 and CX32-2
1. Release the latch at the top on the inside of the front cover by pushing down the hook
(see the following figure).
2. Remove the front cover with a forward motion.
+RRN
/RFN
3LYRWLQJKLQJH
Figure 3-4 Opening the front cover using the D4x5-2 as an example
To Next Page
Loading...
Need help?
General
