Installing
2.2 Installing the SIMOTION D4x5-2
SIMOTION D4x5-2
Commissioning and Hardware Installation Manual, 02/2012
31
2.2.4 Mounting the SIMOTION D445-2 and D455-2 without spacers (external air
cooling)
Purpose of this type of installation
If you want to externally cool a control unit with cooling fins (D445-2 DP/PN and
D455-2 DP/PN), it can be mounted directly on the rear wall of the control cabinet without
spacers.
Requirements
● The bushing for the cooling fins (external heat sink) has been fitted in the rear wall of the
control cabinet.
● Please ensure the area around the seal is both smooth and clean (
② please see figure
titled "Panel cutout").
● Seal available (for the order number, see the
SIMOTION D4x5-2
Manual, Section
Spare
parts and accessories
)
,QVWDOODWLRQFXWRXW
IRUKHDWVLQN
PD[5
&DELQHWUHDUSDQHO
Figure 2-4 Panel cutout
To Next Page
Loading...
Need help?
General
