SIMOTION D4x5-2
Commissioning and Hardware Installation Manual, 02/2012
27
Installing
2
2.1 Installation notes
Open components
These modules are open equipment. This means they may only be installed in housings,
cabinets, or in electrical equipment rooms that can only be entered or accessed with a key or
tool. Housings, cabinets, or electrical equipment rooms may only be accessed by trained or
authorized personnel. An external fire-protection housing is required.
DANGER
The system must be de-energized when you install the control unit.
2.2 Installing the SIMOTION D4x5-2
2.2.1 Installing the SIMOTION D4x5-2
Requirement
The control unit is installed in a control cabinet along with the SINAMICS components.
The following requirements must be met for installing a control unit:
● The control cabinet has been installed and wired.
● The SINAMICS components should already have been installed and wired.
● Components and tools are available.
Designs
A D4x5-2 control unit is designed similar to a SINAMICS S120 booksize unit. It is mounted
directly on the wall of the control cabinet, whereby a distinction is made between the
following designs.
● Mounting the SIMOTION D4x5-2 with spacers
● Mounting the SIMOTION D425-2 and D435-2 without spacers
● Mounting the SIMOTION D445-2 and D455-2 without spacers (external air cooling)
To Next Page
Loading...
Need help?
General
