Standards and approvals
B.2 SIMOTION D4x5 device-specific notes
SIMOTION D4x5-2
Commissioning and Hardware Installation Manual, 02/2012
381
General warning information
CAUTION
There is a risk of injury or of damage to assets. In hazardous areas, personal injury or
damage to assets can occur if plug-in connections are disconnected during operation.
Make sure that your system is always de-energized before disconnecting plug-in
connections in hazardous areas.
C-Tick
AUSTRALIA
D425-2 DP, D425-2 DP/PN, D435-2 DP, D435-2 DP/PN, D445-2 DP/PN,
D455-2 DP/PN, CX32-2 and CBE30-2 meets the requirements of the
AS61800-3.
B.2 SIMOTION D4x5 device-specific notes
Note regarding SIMOTION D
Note
The product standard EN 61800-3 describes the EMC requirements placed on "Variable-
speed drive systems". As such, it defines different limits depending on the location of the
drive system.
SINAMICS S120 power units are designed for use in the second environment. The term
second environment refers to all locations outside residential areas. These are basically
industrial areas which are supplied from the medium-voltage line supply via their own
transformers.
The same installation instructions apply for the SIMOTION D4x5/CX32 Control Units as for
the SINAMICS S120 CU320 Control Units with regard to EMC.
It is essential to follow the installation instructions in the SINAMICS S120 Manuals in order to
ensure compliance with emitted interference and immunity values.
For more information on this topic also refer to Catalog PM21 as well as the SINAMICS
Function Manuals.
To Next Page
Loading...
Need help?
General
