Commissioning (software)
6.12 Configuring drive-related I/Os (with symbolic assignment)
SIMOTION D4x5-2
260 Commissioning and Hardware Installation Manual, 02/2012
6.12.1.2 Configuration of the D4x5-2 I/Os (terminal X142)
Procedure
The I/Os of terminal X142 are permanently assigned to the SIMOTION D4x5-2. The
configuration is therefore performed via the D4x5-2 ("D4x5-2" > "X142 inputs/outputs).
Alternatively, the dialog box can also be called in HW Config by double-clicking the X142
interface.
Figure 6-52 Configuration of the D4x5-2 I/Os (terminal X142)
Addresses tab
The start address for the X142 I/Os can be set in the "Addresses" tab. The address can be
specified or automatically assigned by the system.
To Next Page
Loading...
Need help?
General
