Siemens SIMOTION D435-2 Commissioning And Hardware Installation Manual

Service and maintenance
7.1 Overview
SIMOTION D4x5-2
312 Commissioning and Hardware Installation Manual, 02/2012
1)
Downloading project to
the target system
Upgrading SINAMICS
5)
Firmware update using a
CompactFlash card
Backing up the CompactFlash
card data
Selecting between the three update methods
Update via CompactFlash card
only possible if valid
rmware is located on the
CompactFlash card
Update using the
device update tool
Upgrade via IT DIAG
Update - preparatory measures
2)
Check whether a new device
requires a new boot loader
2)
Check whether the new
version requires a new boot
loader
Upgrading the boot loader on the
CompactFlash card
Run rmware and/or project update
Save/compile project; check
consistency
Libraries can be
device-dependent
Libraries are
version-
dependent
Upgrading a library
Only as
required for
external CUs
3)
Upgrading device version of
SINAMICS S120 CUs
Upgrading technology
packages (TP)
Device replacement in HW Cong
Preparing the device replacement
The target version (= version of the device into which import
is performed) is also specied when the platform is replaced
Platform replacement via
XML export/import
Upgrading a user project to the new
SCOUT version
only if required
only if
required
Backing up user data
(backing up variables)
Creating backup copy
(project/CompactFlash)
D445
(SM150)
D445
(S120)
D445-2D410
D445-2C240
D410 PN D410 DP
D4x5-2 D4x5
D455-2D445-2
V2.6.2
V2.5
PN2.2
PN2.1
V4.1 SP4
V4.1 SP2
V4.2
V4.1
Examples
Platform replacement
via XML export/import
Device replacement
via HW Cong
SINAMICS
version
PROFINET
version
Service pack or
hotx version
Main
version
Action/measure
Upgrading a project
Overview of upgrade options
4)
4) 4)
only if required
Memory card/target hardware SIMOTION SCOUT/project
Replacement of the SIMOTION controller
Activity
aects
Libraries can be
device-dependent
only possible if valid
rmware is located on the
CompactFlash card
not relevant relevant
1)
Alternative: Load the project to the Compact Flash card using a card reader
2)
See SW compatibility list (http://support.automation.siemens.com/WW/view/en/18857317)
3)
The versions of SINAMICS Integrated and Controller Extensions are upgraded automatically in the HW Config
during device replacement
4)
The technology packages are automatically upgraded. If necessary a TP can be specified by the user
5)
SINAMICS components are upgraded/downgraded to the component version of the CompactFlash card. Ensure
that LED codes are observed. After the upgrade it is necessary to switch the device off and on.
Figure 7-1 Overview of upgrade options

Siemens SIMOTION D435-2 Specifications

General

Brand	Siemens
Model	SIMOTION D435-2
Category	Control Unit
Language	English