Chapter 3: Service program PowerSys SWT 3000 Equipment Manual
Page - 20 Edition p3_3_2x 08/09 © SIEMENS AG 2008
Firmware upgrade with MemTool
General information
This description is the upgrade instruction for the controller cards of PowerLink and SWT 3000.
For firmware download of PowerLink and SWT 3000 a dedicated Flash PROM programming tool
can be used. The MemTool flash programming software is provided with the PowerSys CD-ROM
and ensures easy and quick product upgrade if required.
The document describes the upgrade of PowerLink_CSP and SWT 3000_PU3 units in the All In
One mode. Target files are delivered as AllInOne*.jnk. Typically the files are part of the PowerSys
software package available on CD-ROM.
System Requirements
To run MemTool at least the following minimum system configuration is required.
• IBM Personal Computer or 100% compatible
• Pentium (or higher) processor running at 90 MHz with 32 MByte RAM
• Operating System Windows 2000 (SP2 or higher), Windows XP
• Adobe Acrobat Reader 4.0 or higher
• 10 MByte space on local hard-disk
• CD-ROM drive for installation
• Standard serial port interface
Version of MemTool
MemTool release V1.12
To Next Page
Loading...
Need help?
General
