To Next Page

To Previous Page

SWT 3000 Equipment Manual Installation and Commissioning

Warning!

The equipment may be supplied by different and from each other inde-

pendent dangerous voltages. Before opening the equipment and starting

the maintenance work, the device must be isolated with the specified cir-

cuit breaker.

This product complies with the directive of the Council of the European

Communities on the approximation of the laws of the member states re-

lating to electromagnetic compatibility (EMC Council Directive

89/336/EEC) and concerning electrical equipment for use within specified

voltage limits (Low-voltage Directive 2006/95/EC).

This conformity has been proved by tests performed according to Article

10 of the Council Directive in agreement with the generic standards EN

61000-6-2 and EN 61000-6-4 (for EMC Directive) and with the standard

EN 60950-1 (for Low-Voltage Directive) by Senton. The device is de-

signed and manufactured for application in industrial environment.

These devices are designed for use in the industrial sector and fulfil the following requirements:

Emitted interference: EN 61000-6-4: 2001

Immunity to interference: EN 61000-6-2: 2005

For use in residential areas you also need the individual authorization of a national authority or

test agency with respect to emitted interference.

The test and connection jacks accessible at the front are not isolated interfaces and are only used

for maintenance purposes. The usual ESD measures must be observed in use. This also applies

for the use of telephone connection sockets (if present).

All signal and data cables are shielded and connection of the shielding over a large area must be

provided at both ends.

The products and systems listed here are manufactured and marketed

using a DQS-certified quality management system in accordance with

DIN ISO 9001 (Certificate Registration Number 000876 QM UM). The

DQS certificate is recognized in all EQ network countries (Reg. No.: 876)

Transport and storage

The limit values specified below must not be exceeded during transport and storage of PowerLink

devices and individual modules. They may only be transported in their unopened original packag-

ing.

If stored in their unopened original packaging there are no additional requirements for the storage

room apart from the values for temperature and humidity specified below. If stored unpacked or

partially unpacked please ensure that the devices and modules are stored in maintained, dry and

dust-free rooms.

permissible ambient temperature -40° to +70°C

relative humidity 5 to 95%

DIN ISO 9001

Siemens SWT-3000 User Manual

Questions and Answers: