Suzuki Samurai 1986 - Gear Shift Fork

Fig. 13-63
@ High and reverse gear shift fork
@ Low speed gear shift fork
NOTE:
Gear shift fork
the same.
*e
Fig. 13-65
Note that 3 shift shafts individually have a
locating ball and locating spring, and that 2
interlock balls and an interlock roller are used
between shafts as shown in Fig. 1364.
Fig. 13-64
Install low, high and reverse shafts in that order.
1) Install 3 locating springs into 3 holes in
upper case.
Fit locating ball ( @ in Fig.
13-64) on top of locating spring in hole.
1. Locating spring
2. Locating ball @
3. Upper case
2) Insert low speed gear shift shaft into upper
case and low speed shift fork in the direction
as shown in Fig. 1366.
9-r
Fig. 13-66
3) As shown below, push down low speed gear
shift shaft locating ball to pass shaft over it
and keep inserting shaft until locating ball
fits in center slot of 3 continuous slots in
shaft.
Drive shift yoke pin into fork and shaft.
13-20