Other bus types. Other serial bus types, such as CAN, USB, I2C, FlexRay, and so on, are available as purchasable options.
Once purchased and installed, the new bus types are shown in the Bus Type menu. The serial bus options also add
corresponding bus trigger capabilities to the Trigger menu.
ARINC 429 serial bus menu on page 192
CAN serial bus configuration menu on page 196
Ethernet serial bus menu on page 198
FlexRay serial bus configuration menu on page 200
I2C serial bus configuration menu on page 202
LIN serial bus configuration menu on page 204
MIL-STD-1553 serial bus menu on page 205
Parallel Bus configuration menu on page 207
RS232 serial bus menu on page 209
SENT serial bus configuration menu on page 211
SPI serial bus configuration menu on page 213
SPMI serial bus configuration menu on page 215
USB serial bus configuration menu on page 217
See also.
Bus Trigger configuration on page 342
Bus Search configuration menus on page 230
CAN serial bus configuration menu
Use the CAN bus menu (optional) to set up and display a CAN (Controller Area Network) or CAN FD serial bus waveform.
To create a new CAN bus waveform:
1. Tap Add New Bus on the Settings bar.
2. Double-tap the CAN badge to open the bus configuration menu.
3. Set the Bus Type to CAN.
To change the settings on an existing CAN serial bus waveform, double-tap the CAN waveform badge on the Settings bar to
open the configuration menu.
Menus and dialog boxes
196 MSO54, MSO56, MSO58, MSO58LP, MSO64 Help
To Next Page
Loading...
Need help?
General
