Moving badges in the measurement Results Bar
â–
A Measurement or Search badge can only be moved within the Results Bar.
â–
Dragging a badge to a new location causes the non-selected badges to move to create the position at which to insert the
badge.
â–
Once you have moved any Results badge to a new position, adding a new Measurement or Search badge adds that badge
to the bottom of the Results bar badges.
â–
To move a badge to a position that is off screen of the displayed bar badges (scroll buttons are present), drag the badge
that you're moving onto one of the scroll buttons. The badges that are off screen shift onscreen one at a time until you move
the badge off of the scroll button and position it in the displayed badges.
â–
Changing the order of Measurement badges in the Results Bar changes the order of measurements shown in a Results
table.
Configuration menus
Configuration menus let you quickly set the parameters for channels, system settings (Horizontal, Trigger, Acquisition),
measurements, cursor readouts, Waveform and Plot views, note text, and so on.
Double-tap an item (badge, Waveform View or Plot View, cursor readouts, note text, and so on) to open its configuration menu.
For example, double-tap a Channel badge in the Settings Bar to open its configuration menu.
Selections or values that you enter take effect immediately. Menu contents are dynamic, and can change depending on your
selections, instrument options, or attached probes.
Related settings are grouped into 'panels.' Tap the panel name to show those settings. Changes to panel settings can change
the values and/or fields shown in that panel and other panels.
Getting acquainted with your instrument
MSO54, MSO56, MSO58, MSO58LP, MSO64 Help 59
To Next Page
Loading...
Need help?
General
