Field or control Description
No Response Sets to search on data that is all zeros (no response). All values in the Data field are set to zero
and cannot be edited.
Available when Mark On = Master Read, Register Read, Extended Register Read, Ext.
Register Read Long, DD Block Master Read, DD Block Slave Read, or Transfer Bus
Ownership.
Copy Trigger Settings to
Search
Sets the search criteria to match the current oscilloscope trigger settings.
Copy Search Settings to
Trigger
Sets the current oscilloscope trigger settings to match the search criteria.
USB serial bus search configuration menu
Use the USB Search configuration menu to define conditions to search for and mark on an USB bus waveform. You can have
multiple searches on the same bus.
NOTE. Requires option SRUSB2.
Field or control Description
Display Enables or disables displaying search marks on this search.
Stop Acquisition if Event
Found
Stops input acquisition when the search event occurs. Default is not enabled.
Source Select the USB bus that you want to search.
Mark On Select the type of information for which to search.
Handshake Type Sets the handshake packet type for which to search.
Only available when Mark On = Handshake Packet.
Packet Type Sets the special packet type for which to search.
Only available when Mark On = Special Packet.
Error Type Sets the error type for which to search.
Only available when Mark On = Error.
Address Sets the token packet address pattern for which to search. Use in conjunction with the Mark
When field to specify the exact search condition.
Tap the Binary, Hex, or Decimal field and use the A and B knobs to select and change the
values. Or double-tap on the field and use the virtual keypad to enter values.
Only available when Mark On = Token Packet and Token Type = all except SOF (0101).
Token Type Sets the token packet type for which to search.
Only available when Mark On = Token Packet.
Menus and dialog boxes
248 MSO54, MSO56, MSO58, MSO58LP, MSO64 Help
To Next Page
Loading...
Need help?
General
