Field or control Description
A, B knob controls Use the A knob to select (highlight) the digit(s) to change.
Use the B knob to change the value of the digit(s).
Copy Trigger Settings to
Search
Sets the search criteria to match the current oscilloscope trigger settings.
Copy Search Settings to
Trigger
Sets the current oscilloscope trigger settings to match the search criteria.
SENT serial bus search configuration menu
Use the SENT Search configuration menu to define conditions to search for and mark on an SENT bus waveform. You can have
multiple searches on the same bus.
NOTE. Requires option SRAUTOSEN.
Field or control Description
Display Enables or disables displaying search marks on this search.
Stop Acquisition if Event
Found
Stops input acquisition when the search event occurs. Default is not enabled.
Source Select the SENT bus that you want to search.
Mark On Select the type of information for which to search.
Channel Sets the SENT channel type for which to search.
Available when Mark On = Start of Packet.
Status / Communications Sets the value of the status/communications nibble for which to search.
Tap the Binary or Hex field and use the A and B knobs to select and change the values. Or
double-tap on the field and use the virtual keypad to enter values.
Available when Mark On = Fast Channel.
Fast Channel 1 Sets the condition and value of the fast channel 1 data for which to search.
Tap the down arrow and select the condition for which to search (=, ≠, >, <, ≥, ≤). The default is
=.
Tap the Binary or Hex field and use the A and B knobs to select and change the values. Or
double-tap on the field and use the virtual keypad to enter values.
Available when Mark On = Fast Channel.
Fast Channel 2 Sets the condition and value of the fast channel 2 data for which to search.
Tap the down arrow and select the condition for which to search (=, ≠, >, <, ≥, ≤). The default is
=.
Tap the Binary or Hex field and use the A and B knobs to select and change the values. Or
double-tap on the field and use the virtual keypad to enter values.
Available when Mark On = Fast Channel.
Menus and dialog boxes
244 MSO54, MSO56, MSO58, MSO58LP, MSO64 Help
To Next Page
Loading...
Need help?
General
