SPMI serial bus trigger settings panel
NOTE. Requires option SRPM.
Field or control Description
Source Select the SPMI bus on which to trigger.
Trigger On Select the type of information on which to trigger.
Slave Address Sets the slave address value on which to trigger.
Tap the Binary or Hex field and use the A and B knobs to select and change the values. Or
double-tap on the field and use the virtual keypad to enter values.
Available when Trigger On = Reset, Authenticate, Register Read, Register Write, Extended
Register Read, Extended Register Write, Ext. Register Read Long, Ext. Register Write
Long, DD Block Slave Read, or Register 0 Write.
Authenticate Sets the authentication condition on which to trigger.
Available when Trigger On = Authenticate.
Master Address Sets the master address value on which to trigger.
Tap the Binary or Hex field and use the A and B knobs to select and change the values. Or
double-tap on the field and use the virtual keypad to enter values.
Available when Trigger On = Master Read, Master Write, or DD Block Master Read.
Register Address Sets the register address value on which to trigger.
Tap the Binary or Hex field and use the A and B knobs to select and change the values. Or
double-tap on the field and use the virtual keypad to enter values.
Available when Trigger On = Master Read, Master Write, Register Read, Register Write,
Extended Register Read, Extended Register Write, Ext. Register Read Long, or Ext.
Register Write Long.
Data Sets the data value on which to trigger.
Tap the Binary or Hex field and use the A and B knobs to select and change the values. Or
double-tap on the field and use the virtual keypad to enter values.
Available when Trigger On = Master Read, Master Write, Register Read, Register Write,
Extended Register Read, Extended Register Write, Ext. Register Read Long, Ext. Register
Write Long, DD Block Master Read, DD Block Slave Read, or Register 0 Write.
Menus and dialog boxes
372 MSO54, MSO56, MSO58, MSO58LP, MSO64 Help
To Next Page
Loading...
Need help?
General
