To Next Page

To Previous Page

ADJUSTMENT

3 - 7

3.2.3 Printer related adjustment

[A] Reproduction ratio of primary scanning direction (Fine adjustment of polygonal motor rota-

tion speed (Printer))

(1) While pressing [0] and [5] simultaneously, turn the power ON. → (Adjustment Mode)

(2) Press [1] → [FAX]. (A grid pattern with 10 mm squares is printed out. Use A3/LD from the lower

drawer.)

(3) Measure the distance A from the 1st line to the 21st line of the grid pattern.

(4) Check if the distance A is within 200±0.5 mm.

(5) If not, use the following procedure to change values and measure the distance A again.

(Adjustment Mode) → (Key in code [401]) → [START]

→ (Key in a value (acceptable values: 0 to 255))

→ [ENTER] or [INTERRUPT] (Stored in memory)

→ "100% A" is displayed.

→ Press [1] → [FAX] → (A grid pattern is printed out.)

* The larger the adjustment value is, the longer the distance A becomes. (approx. 0.125 mm/

step)

[B] Primary scanning data laser writing start position (Printer)

(1) While pressing [0] and [5] simultaneously, turn the power ON. → (Adjustment Mode)

(2) Press [1] → [FAX]. (A grid pattern with 10 mm squares is printed out. Use A3/LD from the lower

drawer.)

(3) Measure the distance B from the left edge of the paper to the 6th line of the grid pattern.

(4) Check if the distance B is within 52±0.5 mm.

(5) If not, use the following procedure to change values and measure the distance B again.

(Adjustment Mode) → (Key in the code [411]) → [START]

→ (Key in a value (acceptable values: 0 to 255))

→ [ENTER] or [INTERRUPT] (Stored in memory).

→ "100% A" is displayed

→ Press [1] → [FAX] → (A grid pattern is printed out.)

* The larger the adjustment value is, the longer the distance B becomes. (approx. 0.05 mm/

step)

(6) After the adjustment for the code 411 is completed, apply the same adjustment value for the

code 410.

(Adjustment Mode) → (Key in the code [410]) → [START]

→ (Key in the same value in the step 5 above)

→ Press [ENTER] or [INTERRUPT] (Stored in memory).

Note: Note:

Make sure the first line of the grid pattern is printed out since the line is occasionally vanished.

04/09

Toshiba e-STUDIO350 User Manual

Other manuals for Toshiba e-STUDIO350