Frame and Bodywork
Engine Infill Panels Front Mudguard
Engine infill panels are fitted to the frame, towards the
rear of the engine,
on
both sides of the motorcycle.
Removal
Removal
Before starting work, ensure the motorcycle is
stabilised and adequately supported. This will help
prevent it from falling and causing injury to the
operator or damage to the motorcycle.
Before starting work, ensure the motorcycle
is
stabilised and adequately supported. This will help
prevent it from falling
and
causing injury to the
operator or damage to the motorcycle.
1.
Undo the fixings securing the mudguard shrouds
to the fork legs.
<:
1
1. Mudguard shroud
2. Mudguard shroud fixings
3. Fork leg
2. Detach both shrouds.
3. Detach the brake hoses from their clips
on
each
side of the mudguard.
1. Release the two screws securing each panel to
the frame.
Installation
1. Infill
panel
2. Withdraw the infill panel.
Note:
• A connector bracket
is
located behind
the
infill panel on the left hand side.
1.
Position the left hand engine infill panel to the
frame. Align the screw holes
in
the panel with
those
in
the connector bracket and frame.
2.
Fit the screws and tighten to 3 Nm.
3. Repeat for the right hand panel.
Note:
• There is
no
connector bracket on the
right
hand side.
1. Brake hoses
2. Clips
17.10
Service Manual - Rocket
III
To Next Page
Loading...
Need help?
General
