4 Fax
142
Fax
4
[Delayed Start - Start Time] Screen
Specify the start time.
1
Select [AM] or [PM].
2
Enter [Hours] and [Minutes].
Important • If you press the <Start> button
after the specified time, the
stored document will be sent
at the specified time on the
following day.
Send Header (Adding Sender Name and Phone Number to Faxes)
The Send Header feature adds the start time, sender name, recipient name, G3 ID, and
number of pages onto the transmitted document.
This feature enables the recipient to confirm when and from whom the fax was sent.
Important • The Send Header is printed at the top of the document, so an area of about 3 to 5 mm may
not be printed at the top of each page at the remote machine.
Note • If the document is resent, "Resend" is printed at the left of the date and time indication.
• If this feature is enabled for Broadcast transmission, header information is attached to faxes
for all the recipients.
• The start time is printed in the format set on the machine (12 or 24 hour clock). For
information on setting the time, refer to "Time" (P.267).
• For information on the sender name and G3 ID, refer to "Local Terminal Information"
(P.313).
• The recipient name is only added if it has been registered in the address number.
• The default value of [Send Header] can be changed in the System Administration mode. For
information on how to change the default values, refer to "Send Header" (P.307).
1
Select [Send Header] on the
[Transmission Options] screen.
2
Select [On].
îš„Off
No sender information is added.
îš„On
Sender information is added.
To Next Page
Loading...
Need help?
General
