4 Fax
150
Fax
4
• You can specify any machine that supports our DTMF method feature.
• By registering destinations into address numbers using the above dialing formats, you can
use the address numbers for the Private Polling feature. For information on how to register
address numbers, refer to "Address Book" (P.328).
F Code (Using F Code Transmission)
F Code is the transmission procedure set by the Communications and Information
Network Association of Japan and is the T.30 (communication protocol) method for
using sub-addresses that was standardized by the ITU-T. The F Code feature enables
various features to be used with transmission among F Code-compatible machines
manufactured by different companies.
When using F Code transmission, use an F Code and password. The F Code, which is
also called a sub-address by other companies, must be registered (entered). Set the
password if necessary.
Note • This feature is not available for Server Fax except when an F code is included in a dialing
number.
• To use the F Code feature, you need to confirm the F Code of the recipients machine in
advance.
• You can set the F Code and password for each address number. For information on how to
register address numbers, refer to "Address Book" (P.328).
• You can use Relay Broadcast/Remote Relay Broadcast with F Code transmission. For
information on Relay Broadcast, refer to "Relay Broadcast (Transmitting Documents
Through a Relay Station)" (P.158). For information on Remote Relay Broadcast, refer to
"Remote Relay Broadcast (Performing Relay Broadcast to Remote Locations)" (P.162).
• We recommend using the fax signal method for sending to a mailbox or private polling when
the recipient is using the same model of machine.
You can use the following features with F Code transmission.
îš„Sending to Mailbox (F Code Method)
When a mailbox is set on a remote machine, you can send a document directly to the
mailbox by specifying the F code (sub-address) and password (if set up) of the mailbox.
Obtain the F Code (sub-address) and password of the destination mailbox in advance.
Example of specifying a destination:
F Code (sub-address) : 0 (to designate an F Code transmission) and the
mailbox number of a mailbox on the remote machine
Password (if necessary) : The password of the mailbox
îš„Private Polling (F Code Method)
When a mailbox is set on a remote machine, you can perform private polling for the
mailbox by specifying its F code (sub-address) and password (if set up).
If you use your machine to perform private polling for a mailbox on a remote machine,
obtain the F Code (sub-address) and password of the target mailbox.
If you use a remote machine to perform private polling for a mailbox on your machine,
give the following information.
F Code (sub-address) : 0 (to designate an F Code transmission) and the
mailbox number of the target mailbox
Password (if necessary) : The password of the target mailbox
To Next Page
Loading...
Need help?
General
