Copy Mode Settings
291
System Settings
10
Covers - Covers Tray
Set the default value for [Covers Tray] in the [Covers] screen.
Build Job - Separators Tray
Set the default value for [Separators] in the [Build Job - Separators Tray] screen.
Copy Control
These settings relate to copy operation control.
Memory Full Procedure
When the space of the hard disk runs out during scanning originals, a screen appears asking
how the partly stored data should be handled.
Once a certain time has elapsed with the confirmation screen displayed, the subsequent
processing is determined based on this setting.
You can set the period of time until the memory full procedure is carried out. For more information,
refer to "Auto Job Release" (P.268).
îš„Cancel Job
The stored data is discarded.
îš„Run Job
The stored data is copied.
Maximum Stored Pages
Set the maximum number of copy pages that the machine can store. You can specify a value
in the range of 1 to 999.
Auto Paper Off
Select the tray used when [Auto Paper] of [Paper Supply] in the [Copy] screen is cancelled
(the tray used when [Auto Paper] of [Paper Supply] is selected in the [Copy] screen, and
[Auto %] or [Independent X-Y %] is selected for [Reduce/Enlarge]).
Mixed Sized Originals - 2 Sided Copy
Select the action to be taken if the paper size determined for the document page to be printed
on the front side of paper is different from the paper size determined for the document page
to be printed on the back side of the paper.
Important • If [Copy to Side 2] is selected, some areas of the image may be cropped.
îš„Copy to new sheet
Side 2 is copied on the front of a new sheet.
îš„Copy to Side 2
Side 2 is copied on the opposite side of Side 1 without changing the paper size.
Fine-tune 100%
You can fine-tune the magnification when copying at 100% (actual size). The set value is
applied when [Reduce/Enlarge] or [Preset %] on the [Copy] screen is set to 100%.
Set the value in the X/Y direction within the range 98 to 102% in 0.1% increments.
Important • This feature is applied only when a copy is made with the document glass. This setting is not
reflected in the magnification (100%) under [Variable %], [Independent X-Y%] or [Calculator
%].
Note • A magnification displays [100%] even if [Fine-tune 100%] is set.
To Next Page
Loading...
Need help?
General
