ESC/P-K Emulation
549
Appendix
16
Fonts
This section explains the fonts used for emulation.
Available fonts
Available fonts are the followings:
z
Roman
z
Sans serif
User-defined Characters
On this machine, you can use user-defined characters. User-defined characters can be
stored only in memory. Therefore, they are erased when the machine is switched off.
When the HDD Extension Kit (optional) is added to the machine, user-defined
characters can be stored on the hard disk, and are not erased even when the machine
is switched off. The volume of user-defined characters that can be stored on the hard
disk drive is the same as the volume when stored in memory.
The total capacity of memory for storing user-defined characters and other user-
defined data can be set on the control panel. This value is retained after the machine
is switched off.
User-defined characters are registered as bitmap fonts, and cannot be shared among
different printer languages.
Font Caching
To ensure high-speed printing, outline fonts of up to a certain size are cached. Outline
fonts are converted into bitmap data temporarily and then printed. To minimize this
processing time, the processed bitmap data is saved in the memory. This process is
called font caching.
The saved bit map data is deleted upon power-off or system reset.
Output Feature
This section describes the machine's output feature.
Outputting a Pending Print Job
The jobs received by the printer can be prioritized over other jobs.
For information on how to give priority to the jobs received by the printer, refer to "Printing Pending
Jobs" (P.363).
To Next Page
Loading...
Need help?
General
