Zebra WT6000 Series User Manual

Maintenance and Troubleshooting
161
Cradles
A message appears
stating that the WT6000
memory is full.
Too many files stored
on the WT6000.
Delete unused memos and records. You can save these
records on the host computer.
Too many
applications installed
on the WT6000.
If you have installed additional applications on the WT6000,
remove them to recover memory. See Uninstalling an
Application on page 149.
The WT6000 does not
accept scan input from
optional scanner.
Unreadable bar code. Ensure the symbol is not defaced.
Distance between
scanner exit window
and bar code is
incorrect.
Move the scanner closer or further from the bar code to the
proper scanning range.
WT6000 is not
programmed for the
bar code.
Verify that the WT6000 can read the type of bar code being
scanned (See <em_Emphasis>Appendix , Specifications).
Ensure that the bar code parameters are set properly for the
bar code being scanned.
WT6000 is not
programmed to
generate a beep.
Verify that a beep on a good decode is used. See Bar Code
Input on page 75 for more information.
During USB data
communications, no
data was transmitted, or
transmitted data was
incomplete.
Incorrect cable
connection.
See Accessories.
Communications
software is not
installed or
configured properly.
Perform setup as described in
Accessories.
Table 10 Troubleshooting the WT6000 (Continued)
Problem Cause Solution
Table 11 Troubleshooting the Cradles
Symptom Possible Cause Solution
Device battery is
not charging.
Device was removed
from cradle or cradle
was unplugged from AC
power.
Ensure cradle is receiving power. Ensure device is seated
correctly. Confirm main battery is charging. The battery fully
charges in approximately four hours.
Battery is faulty. Verify that other batteries charge properly. If so, replace the
faulty battery (see Installing the Battery on page 17).
The device is not fully
seated in the cradle.
Remove and re-insert the device into the cradle, ensuring it is
firmly seated.
Ambient temperature of
the cradle is too warm or
too cold.
Move the cradle to an area where the ambient temperature is
between 0°C and 40°C (32°F and 104°F).

Zebra WT6000 Series Specifications

General

Brand	Zebra
Model	WT6000 Series
Category	Handhelds
Language	English