To Next Page

To Previous Page

DataWedge Configuration

• Connection Idle Time - Set connection idle time. The Bluetooth connection disconnects after being idle

for set time (RS507 and RS6000 only).

• Decode Haptic Feedback - Enable the device to vibrate upon a good decode (default - enabled).

• Display BT Address Barcode - Enable or disable displaying Bluetooth Address bar code if there is no

Bluetooth scanner being paired when application tries to enable the Bluetooth scanner (RS507 and

RS6000 only).

• Establish Connection Time - The timeout which the WT6000 will try to enable or reconnect to the

Bluetooth scanner when the Bluetooth scanner is not in the vicinity or not paired (RS507 and RS6000

only).

• Audio Feedback Mode - Select good decode audio indication.

• Local Audio Feedback - Good decode audio indication on WT6000 only.

• Remote Audio Feedback - Good decode audio indication on scanner only.

• Both - Good decode audio indication on WT6000 and scanner.

• Disable - No good decode audio indication on either WT6000 or scanner (default).

• LED Feedback Mode - Select good decode LED indication.

• Local LED Feedback - Good decode LED indication on WT6000 only.

• Remote LED Feedback - Good decode LED indication on scanner only.

• Both Good decode LED indication on WT6000 and scanner (default).

• Disable - No good decode LED indication on either WT6000 or scanner.

• Decode Audio Feedback - Select an audio tone to sound upon a good decode.

• Decoding LED Notification - Enable the device to light the red Data Capture LED when data capture is in

progress. (default - disabled).

• Decode Feedback LED Timer - Set the amount of time (in milliseconds) that the green Data Capture LED

stays lit after a good decode. (default - 75 msec.)

• Beep Volume Control - Set the good decode beep to a system or other sound. This allows for

independent control of the good beep volume.

• Ringer - Set the good decode beep to the ringer sound.

• Notifications - Set the good decode beep to the notification sound (default).

• Alarms - Set the good decode beep to the alarm sound.

UDI Params

Not supported.

Multibarcode Params

Not supported

Keep enabled on suspend

Keep Bluetooth or corded scanner enabled after suspend (default-disabled). This allows the user to wake the

device by pressing the scan trigger.

NOTE: Not all ringtones are fully supported as decode tones and those of longer length may be truncated when

used as a decode tone. The recommendation is to test the selected tone for operation before deployment to a

customer site.

Zebra WT6000 Series User Manual

Questions and Answers: