66
USB Communication
Introduction
This chapter provides information for transferring files between the device and a host computer.
Connecting to a Host Computer via USB
Connect the WT6000 to a host computer using the USB/Charge Cable, 1-Slot Charging Cradle, or 2-Slot Charging
Cradle to transfer files between the WT6000 and the host computer. See Accessories for more information.
Transferring Files using Media Transfer Protocol
1. Connect the Rugged Charge/USB Cable to the WT6000 or place the WT6000 into the 1-Slot Charging Cradle,
or 2-Slot Charging Cradle. See Accessories for setup information.
2. Pull down the Notification panel and touch USB charging this device.
Figure 73 Use USB Dialog Box
3. Touch Transfer files.
4. On the host computer, open a file explorer application.
CAUTION:When connecting the WT6000 to a host computer, follow the host computer’s instructions for
connecting and disconnecting USB devices, to avoid damaging or corrupting files.
To Next Page
Loading...
Need help?
General
