DataWedge Configuration
75
• Drag detect time - Select the time in milliseconds that the scanner waits before activating scanner. This
allows the user to drag the button without initiating scanner (default - 100 ms, maximum 1000 ms).
In Button mode, the user can place DCP in full screen mode by dragging the button over Fullscreen mode. The
overlay covers the screen.
Figure 85 Fullscreen Mode
Swipe down to return to button mode.
Bar Code Input
Use the Bar Code Input options to configure the Bar Code Scanner Input Plug-in for the profile.
Enabled
Enables or disables this plug-in. A check in the checkbox indicates that the plug-in is enabled.
Scanner Selection
Configures which scanning device to use for bar code data capture when the profile is active.
• Auto - The software automatically selects the best scanner.
• Plugable Serial SSI Scanner - Scanning is performed using the RS4000 laser scanner.
• Bluetooth Scanner - Scanning is performed using the RS507 Hands-free Bluetooth scanner.
• RS6000 Bluetooth Scanner - Scanning is performed using the RS6000 Hands-free Bluetooth scanner.
• RS5000 Plugable Serial SSI Scanner - Scanning is performed using the RS5000 imager.
• DS3678 Bluetooth Scanner - Scanning is performed using the DS3678 Bluetooth scanner.
Decoders
Configures which bar code decoders are enabled or disabled. For best performance disable all unnecessary
decoders.
Touch Decoders. The Barcode input screen appears. A check in the checkbox indicates that the decoder is
enabled. By default the most commonly used decoders are enabled (shown below with an asterisk). The supported
decoders are:
NOTE: The DCP does not appear if the scanner is disabled in the profile even though the Enabled option is set.
NOTE: DataWedge supports the decoders listed below but not all are validated on this device.
To Next Page
Loading...
Need help?
General
